Author Topic: Passive speakers to Active Sub  (Read 1249 times)

0 Members and 1 Guest are viewing this topic.

Offline zereque

  • Trade Count: (+1)
  • Apprentice
  • *
  • Posts: 35
  • Liked:
  • Likes Given: 0
Passive speakers to Active Sub
« on: Aug 17, 2015 at 11:45 AM »
Hi guys,

May tanong lang po ako, Pwede ko po bang gamitin ang Passive Speaker ko na Kenwood around 30 Watts to my Edifier - M3300SF 12W x2 + 30 W ang specs nya.

Sira na kasi ang left channel,. so it is possible na gamitin ko ang passive speakers sa Edifier powered sub? 

Thanks and more power Pinoy DVD

Regards,
Rasell :)

Offline cyberdraven

  • Trade Count: (+15)
  • Collector
  • **
  • Posts: 418
  • Old Carabao eats young grass!
  • Liked:
  • Likes Given: 3
Re: Passive speakers to Active Sub
« Reply #1 on: Aug 17, 2015 at 01:09 PM »
Wag ka sa watts tumingin sir.kailangan tama impedence at values ng passives.  Your best best if to restore the existing passives nalang.  Buy caps of the same capacitance.  Also, pa check mo din baka me kailangan lang ihinang sa connectors.
Knowledge is knowing a tomato is a fruit.
Wisdom is not putting it in a fruit salad.

Offline markcrenz

  • Trade Count: (+194)
  • PinoyDVD Legend
  • *****
  • Posts: 4,293
  • Liked:
  • Likes Given: 8
Re: Passive speakers to Active Sub
« Reply #2 on: Aug 17, 2015 at 10:18 PM »
Small 2.1 systems usually have 4 ohm sats and im guessing your kenwoods are 4-8 ohms, so most likely pwede.

Buy caps of the same capacitance.
para saan caps?
Sent from my Pentium 166MMX using PS/2 keyboard

Offline zereque

  • Trade Count: (+1)
  • Apprentice
  • *
  • Posts: 35
  • Liked:
  • Likes Given: 0
Re: Passive speakers to Active Sub
« Reply #3 on: Aug 18, 2015 at 11:56 AM »
its 8 ohms mga sir, so i just need a wire(speakers) to RCA (active sub)  para magamit ko yung Bookshelf speakers?

Thanks sa mga info mga sir, :)





Offline markcrenz

  • Trade Count: (+194)
  • PinoyDVD Legend
  • *****
  • Posts: 4,293
  • Liked:
  • Likes Given: 8
Re: Passive speakers to Active Sub
« Reply #4 on: Aug 18, 2015 at 01:17 PM »
Yes. Siguraduhin mo lang matino yung RCA wires na ikakabit sa Edifier amp outputs to speakers.
Sent from my Pentium 166MMX using PS/2 keyboard

Offline zereque

  • Trade Count: (+1)
  • Apprentice
  • *
  • Posts: 35
  • Liked:
  • Likes Given: 0
Re: Passive speakers to Active Sub
« Reply #5 on: Aug 18, 2015 at 03:49 PM »
Mga sir

thanks sa pagsagot sa post ko,. just to make sure lang, ito po ang full spec ng Edifier ko,

RMS 12W x 2 + 30W x 1
Subwoofer / bass unit: 6½ inch (166mm), Magnetically shielded, 8ohms
Midrange / high unit: 3 inch (78mm), Magnetically shielded, 4ohms
Tweeter unit: 10mm, Magnetically shielded, 4ohms
Impedance: 10K ohms
Signal to Noise Ratio(SNR) >=85dBA


At sa Kenwood naman 30 Watts 8 Ohms