Topic: Pioneer Receivers

[sirhc]

guys, feedback po sa vsx 1022 or vsx 1121. currently in search for my first avr..

[♡ lvcdg23™ ✌]

guys, feedback po sa vsx 1022 or vsx 1121. currently in search for my first avr..

Eto bro side by side specs comparison...

http://receivers.findthebest.com/compare/5-166/Pioneer-VSX-1121-K-vs-Pioneer-VSX-1022-K

[raider125jeigh]

Malayo ung 1022 sa 1121 lalo na kung future proof

[Tavus]

guys, feedback po sa vsx 1022 or vsx 1121. currently in search for my first avr..

I would pick the vsx 1121, pioneer downgraded the 1022 to a lower end model to accommodate the 1122

spec wise the 1121 crushes the 1022 in terms of power
1121 (20Hz-20kHz,.08%THD@8ohm) is 110, 7 hdmi 2 sub outs and pre outs
1022 (20Hz-20kHz,.08%THD@8ohm) is 80, 6 hdmi 1 sub out and non.

http://www.pioneerelectronics.com/PUSA/Home/AV-Receivers/Pioneer+Receivers/VSX-1121-K
http://www.pioneerelectronics.com/PUSA/Home/AV-Receivers/Pioneer+Receivers/VSX-1022-K

http://receivers.findthebest.com/compare/5-166/Pioneer-VSX-1121-K-vs-Pioneer-VSX-1022-K
I would be careful with this site, it has a lot of miss leading information. 

[Frankthetank]

Mga sir,  pwede ba  gawing power amp ang dayton dta100a, so that i could add a surround back speaker on my Pioneer vsx521 5.1 avr to make it  7.1?

[raider125jeigh]

Mga sir,  pwede ba  gawing power amp ang dayton dta100a, so that i could add a surround back speaker on my Pioneer vsx521 5.1 avr to make it  7.1?

nalito ako...     5.1 lang ba ung 521?  Kung 5channel lang sya ..poweramp will not make it 7.1.                 ..poweramp should be connected to pre out of receiver to drive speaker for 2 channel it can drive the fronts while receiver will just drive the center and surr

[Frankthetank]

nalito ako...     5.1 lang ba ung 521?  Kung 5channel lang sya ..poweramp will not make it 7.1.                 ..poweramp should be connected to pre out of receiver to drive speaker for 2 channel it can drive the fronts while receiver will just drive the center and surr

5.1 sya sir, pero may pre out sya for surround back or front height. Was wondering if i can use dayton so i could connect a speaker surround

[♡ lvcdg23™ ✌]

5.1 sya sir, pero may pre out sya for surround back or front height. Was wondering if i can use dayton so i could connect a speaker surround

Yes pwede. From Pio preout to Dayton via RCA cable then Dayton to speakers. In fact any power amp will do as long as kaya nyang idrive yung speakers.

[Stagea]

Mga sir,  pwede ba  gawing power amp ang dayton dta100a, so that i could add a surround back speaker on my Pioneer vsx521 5.1 avr to make it  7.1?

You can, as long as you're okay with running within its limits.

[Frankthetank]

Yes pwede. From Pio preout to Dayton via RCA cable then Dayton to speakers. In fact any power amp will do as long as kaya nyang idrive yung speakers.

Nice, thanks sir. Can dayton dta100a drive a polk tsi 100 or owm3 ?

[Frankthetank]

You can, as long as you're okay with running within its limits.

Limits po like??

[AppleMan]

^_Isang power amp pa para naman dun sa FRONT HEIGHT para kumpleto na...

[markcrenz]

Nice, thanks sir. Can dayton dta100a drive a polk tsi 100 or owm3 ?

i think this deserves a different thread

[iconlord]

mga sir's newbie question lang po..

kaya bang i drive ng pioneer vsx 522 ko ang wharfedale 10cm center speaker 30-200w?

as far as i know, 30-140watts per channel ang vsx 522.

ano po ang cons and prons?

thanks !

[Nelson de Leon]

mga sir's newbie question lang po..

kaya bang i drive ng pioneer vsx 522 ko ang wharfedale 10cm center speaker 30-200w?

as far as i know, 30-140watts per channel ang vsx 522.

ano po ang cons and prons?

thanks !

kaya. Wag mo lang lalakasan sa reference levels. Pero at descent movie watching volumes, maayos na siya.

[raider125jeigh]

5.1 sya sir, pero may pre out sya for surround back or front height. Was wondering if i can use dayton so i could connect a speaker surround

un ayos may preout pala .. Sir markcrenz have a hardware to connect poweramp without preout ..isuggest ko sana .. Since may preout it will work ok..       Iconlord(wil) same answer by efren nelson ..un din tinext ko sayo hihihi

[♡ lvcdg23™ ✌]

Nice, thanks sir. Can dayton dta100a drive a polk tsi 100 or owm3 ?

I think it could drive the both TSi100 and OWM3 since they're fairly easily to drive 8-ohms @ 89db...
Just don't push them too hard...

[iconlord]

which is better Yamaha RX V373 or Pioneer VSX-522K?

i have a wharfedale 10cm center and planning to buy wharfe 10.6 fronts.

please help me decide.. thanks

[raider125jeigh]

which is better Yamaha RX V373 or Pioneer VSX-522K?

i have a wharfedale 10cm center and planning to buy wharfe 10.6 fronts.

please help me decide.. thanks

parehas lang entry level yan pre...
522 to 373 is not an upgrade...but a change of brand only....

[Timithekid]

parehas lang entry level yan pre...
522 to 373 is not an upgrade...but a change of brand only....

Baka wala pang receiver sis and yan ang pinagpipilian

[raider125jeigh]

Baka wala pang receiver sis and yan ang pinagpipilian

meron na yan 522
barkada ko yan si iconlord...

bumuo kasi sya lately pero need nya budget frendly
kaya pinabili ko ung 10CM na wharf sa MP an sabi ko 10.6 FS and 9DFS or 10dfs surr

[markcrenz]

sayang nga kung "sidegrade" lang. better step 2-3 models or higher up the series kung galing sa entry level model.

[raider125jeigh]

sayang nga kung "sidegrade" lang. better step 2-3 models or higher up the series kung galing sa entry level model.

yup 
pM ko sya sabi ko kunin ung benta mo sa MP na pioneer...

[nsp]

noob question. can an entry level pio receiver be configured for 2.1 or 3.1 without losing the sound from the unused channels? does it support virtual surround? my plan is to start with 2.1 system and then gradually upgrade to 5.1. i wish to use virtual surround while i have a 2.1 or 3.1 setup. thanks.

[Stagea]

noob question. can an entry level pio receiver be configured for 2.1 or 3.1 without losing the sound from the unused channels?

Yes. If configured right, it should downmix the data.

does it support virtual surround?

Yes, with the right sources. Pioneer calls it Front Stage Surround.

[nsp]

thanks

[markcrenz]

yup 
pM ko sya sabi ko kunin ung benta mo sa MP na pioneer...

thanks for the boost!

[maximuskain]

Hi. Have a pioneer vsx 921 is there a difference if i use 14 gauge speaker wires? I'm currently at 16 gauge and thinking of swapping the front and center to 14gauge.

I'm using Polk TSi300 fronts and CS10 for center.

[iconlord]

Hi. Have a pioneer vsx 921 is there a difference if i use 14 gauge speaker wires? I'm currently at 16 gauge and thinking of swapping the front and center to 14gauge.

I'm using Polk TSi300 fronts and CS10 for center.

hi sir, ilang watts po per channel ang vsx 921 or 922 model? thanks

[iconlord]

I would pick the vsx 1121, pioneer downgraded the 1022 to a lower end model to accommodate the 1122

spec wise the 1121 crushes the 1022 in terms of power
1121 (20Hz-20kHz,.08%THD@8ohm) is 110, 7 hdmi 2 sub outs and pre outs
1022 (20Hz-20kHz,.08%THD@8ohm) is 80, 6 hdmi 1 sub out and non.

http://www.pioneerelectronics.com/PUSA/Home/AV-Receivers/Pioneer+Receivers/VSX-1121-K
http://www.pioneerelectronics.com/PUSA/Home/AV-Receivers/Pioneer+Receivers/VSX-1022-K

http://receivers.findthebest.com/compare/5-166/Pioneer-VSX-1121-K-vs-Pioneer-VSX-1022-K
I would be careful with this site, it has a lot of miss leading information.

newbie question.

does this mean na whenever we connect a 6ohm speakers like wharfedales to vsx-1022 the actual power output that would be given out by the receiver per channel is 140w and if the speaker is 8ohm the receiver power output would be 80w? thanks