Topic: DIY Digital Amp

[odyopayl]

Un-painted chassis checking fittingg holes for RCA's , speaker terminals switch etch:
Size is standard same with CD players
Power switch at left side



Final assembly (2 units Flying Mole Amp-100W)
With Aluminum Faceplate
- Clear anodized
- Hairline finished



Closed-up (Sorry for picture quality came from Cellphone)



With Front Faceplate, attached using screw at the back (non visible)



With only one LED indicator on front via 2mm hole

[kikoman]

OK Pre ang ganda nyan!

[av_phile1]

Nice,  where did you have the faceplate finished?

[odyopayl]

Hi AV Phile This place:

HDM Technologies
26 Argentina St. Paranaque
(about 0.5 km past SM Bicutan, opposite side of the street)
the boss is Hector Malonzo but suggest looking for Ed Gloria
phone 823 0758 or 776 4077
Ed's cell 0917 891 4780

Check this for similar finished of faceplate:

http://wiredstate.com/forum/viewtopic.php?t=9523

[odyopayl]

Kikoman,

The sound is as good as it looks

[av_phile1]

Thanks for that info, odyopayl.  Will certainly keep that in mind when I decide to revive my DIY hobby. Are you feeding that amp from the pre-outs of your HK receiver in the picture?

[macmac09]

where po ba meron flying mole products sa atin. tnx

[ATJr.]

Hi AV Phile This place:

HDM Technologies
26 Argentina St. Paranaque
(about 0.5 km past SM Bicutan, opposite side of the street)
the boss is Hector Malonzo but suggest looking for Ed Gloria
phone 823 0758 or 776 4077
Ed's cell 0917 891 4780

Check this for similar finished of faceplate:

http://wiredstate.com/forum/viewtopic.php?t=9523

is that going to Tanyag? i failed to see this place when i went to OmanFil during the processing of my papers. i will be going there again in july for my visa trip requirements.

Hectro Malonzo rings a bell with me, is the guy that used to be working at Stanford Microsystems in Pasig before?

[marckd1]

 

[Voltraizer]

where po ba meron flying mole products sa atin. tnx

Mac,
Check this out:
http://wiredstate.com/forum/viewtopic.php?p=61291&highlight=#61291
Si maitani of ws ang distributor dito satin.

[odyopayl]

is that going to Tanyag? i failed to see this place when i went to OmanFil during the processing of my papers. i will be going there again in july for my visa trip requirements.

Hectro Malonzo rings a bell with me, is the guy that used to be working at Stanford Microsystems in Pasig before?

======================================================================================

Hi Tony, the place is on the opposite side. Its the way going to SM Bicutan. I believe Hector Malonzo used to be Stanford Guy. And Yes he owns the plant. Super Yaman and yet down to earth!

[odyopayl]

Thanks for that info, odyopayl.  Will certainly keep that in mind when I decide to revive my DIY hobby. Are you feeding that amp from the pre-outs of your HK receiver in the picture?

=======================================================================================
Nope, I'm using tube Pre-amp. This was just tested and just put over the HK.

[odyopayl]

For DIY'r. One of my friend replaced his ST-70 casing with Pure stainless Steel Casing and note Mirror Finished. Forget about Chrome plating. All holes are been copied as replica of the original case.

[rmpmla]

ang galing naman