Dunno if it's just coincidence that 4 or so members here are having problem, or if it's an isolated problem affecting certain users lang since some members here, and other subs, never had signal interruptions..
Might call Cignal nalang, though I don't know how fast they can send in tech support.
PACE Box
1. Unplug the RG6 cable at the back of the receiver
2. Perform hard reset ( unplug and plug in the Cignal box)
3. Wait for the technical problem error to prompt
4. Press “ok” on the remote control
5. Go to “Settings”
6. Plug in the RG6 cable
7. Enter the PIN code (“0000”, “9998” or “9999”)
8. Go to System Setup > Diagnostics
9. Check the current release number
10. The version should be 106
11. Press cancel/back, then select “Installation Setup”
12. Select “Satellite Setup” then press “ok”
13. Set the following:
a) LNB Type: Dual
b) Low Band and High Band LO Frequency: 09750 and 10600
c) LNB Power: “ON” for the main box and “OFF” for the 2nd/3rd box)
14. Select SES7-NE8 entry point and check signal parameters, then press OK