« previous next »
Pages: [1]   Go Down

Author Topic: No sound  (Read 2526 times)

0 Members and 1 Guest are viewing this topic.

Offline strwere

  • Trade Count: (0)
  • Apprentice
  • *
  • Posts: 43
  • Liked:
  • Likes Given: 0
No sound
« on: Jan 19, 2012 at 09:55 AM »


Uploaded with ImageShack.us
sa tuwing kinakabit k ung  3.5mm stereo slipter nawawala ung tunog ng right stereo anu po ba ang mali kong ginawa? pa 2long naman tnx :)
« Last Edit: Jan 19, 2012 at 09:55 AM by strwere »
Logged

Offline louie1

  • Trade Count: (+14)
  • Collector
  • **
  • Posts: 392
  • Liked:
  • Likes Given: 12
Re: No sound
« Reply #1 on: Jan 19, 2012 at 10:34 AM »
try this...
#4 to subwoofer  amp (pls. note, #4 is for center and sub- you only need the sub signal to your pilyo amp.)
#6 to smsl amp l/r input

your speaker setup on your pc sound manager must be 2.1

Logged

Offline strwere

  • Trade Count: (0)
  • Apprentice
  • *
  • Posts: 43
  • Liked:
  • Likes Given: 0
Re: No sound
« Reply #2 on: Jan 19, 2012 at 10:44 AM »
yes sir naka 2.1 ung sound manager ko  pag ung amp4v2 kinabit ko sa #4 no sound naman ung sub :(
Logged

Offline louie1

  • Trade Count: (+14)
  • Collector
  • **
  • Posts: 392
  • Liked:
  • Likes Given: 12
Re: No sound
« Reply #3 on: Jan 19, 2012 at 11:01 AM »
3.5mm stereo plug to rca ba gamit mo to sub, so bale 2 na rca yan sa dulo (red and white) try mo both, kase center and sub ang  #4
Logged

Offline strwere

  • Trade Count: (0)
  • Apprentice
  • *
  • Posts: 43
  • Liked:
  • Likes Given: 0
Re: No sound
« Reply #4 on: Jan 19, 2012 at 12:21 PM »
ganto sir

cord for amp stereo


cord for amp4v2

tapos kakabit ko cya d2


then connect ko cya sa # 6

ala kc ako salam masyado sa ganto sir pasensya na :)
Logged

Offline louie1

  • Trade Count: (+14)
  • Collector
  • **
  • Posts: 392
  • Liked:
  • Likes Given: 12
Re: No sound
« Reply #5 on: Jan 19, 2012 at 05:18 PM »
Quote from: strwere on Jan 19, 2012 at 12:21 PM
ganto sir

cord for amp stereo
you need 2 of this type..


cord for amp4v2

mukhang yong rca to 3.5mmm adaptor is mono type..stereo 3.5mm plug din ang dapat na ikabit mo sa sound card...kaya siguro walang sound (shorted sya), try mo gumamit ng same cables na nakakabit sa smsl amp.



Logged

Offline strwere

  • Trade Count: (0)
  • Apprentice
  • *
  • Posts: 43
  • Liked:
  • Likes Given: 0
Re: No sound
« Reply #6 on: Jan 19, 2012 at 06:00 PM »
ganto kc sir ung likod ng amp ko eh kaya hinid red and white gamit ko.


ang need ko b sir is ganito?

+

sa likod ng amp4v2?

salamat sir tlga :)
« Last Edit: Jan 19, 2012 at 06:22 PM by strwere »
Logged

Offline strwere

  • Trade Count: (0)
  • Apprentice
  • *
  • Posts: 43
  • Liked:
  • Likes Given: 0
Re: No sound
« Reply #7 on: Jan 19, 2012 at 08:07 PM »
Quote from: louie1 on Jan 19, 2012 at 07:39 PM
ang need ko b sir is ganito?



yes sir, but kailangan mo tangalin ang rca connector, since spring/clip type ang connection sa pilyo amp(please verify with Sir Marco Pilyo kung yan nga ang terminal ng line input ng kanyang amp)..
pag pinutol mo ang rca connector, sa loob nito ay may dalawang wire, need mo ng tester or any continuity tester para malaman kung alin ang signal line at ground. kailngan mo imodify yang stereo 3.5mmTSR to rca cable mo

OR bumili ka na lang ng 3.5 TRS (tip, ring, sleeve connector) sa mga suking electronic shop or sa ace hardware, coax cable or any 2 conductor cable available..see drwg. below

di ko kabisado yang sound card mo so you have to experiment kung yong pt A or B ng TSR connector ang signal ng sub from your sound card.

at please make sure that the terminal you mentioned above at Pilyo amp is the line input terminal and NOT the speaker out terminals,


naku sir mali ata



maraming marmaing salamat po tlga sir louie

ung black and red un ung output niya then ung black na bilog un ung input po niya
« Last Edit: Jan 19, 2012 at 08:11 PM by strwere »
Logged

Offline louie1

  • Trade Count: (+14)
  • Collector
  • **
  • Posts: 392
  • Liked:
  • Likes Given: 12
Re: No sound
« Reply #8 on: Jan 19, 2012 at 08:20 PM »
i see..so ang kailngan mo ay yong 3.5mmTSR to rca cable like the one used sa smsl amp...try mo lang kung alin sa red or white rca is the sub signal.. ;D ;D ;D forget the diy cable ;D ;D and enjoy your music ;D

Logged

Offline louie1

  • Trade Count: (+14)
  • Collector
  • **
  • Posts: 392
  • Liked:
  • Likes Given: 12
Re: No sound
« Reply #9 on: Jan 19, 2012 at 08:23 PM »
and dont forget to adjust the gain(vol control knob) ng sub amp to your liking..at check sub volume at your pc sound manager..baka naka-"Mute" ;D ;D
Logged

Offline strwere

  • Trade Count: (0)
  • Apprentice
  • *
  • Posts: 43
  • Liked:
  • Likes Given: 0
Re: No sound
« Reply #10 on: Jan 19, 2012 at 08:53 PM »
sir ok na! maraming maraming salamat po!! :)
Logged

Offline louie1

  • Trade Count: (+14)
  • Collector
  • **
  • Posts: 392
  • Liked:
  • Likes Given: 12
Re: No sound
« Reply #11 on: Jan 19, 2012 at 09:03 PM »
congrats!! enjoy your music!!
Logged

Offline strwere

  • Trade Count: (0)
  • Apprentice
  • *
  • Posts: 43
  • Liked:
  • Likes Given: 0
Re: No sound
« Reply #12 on: Jan 19, 2012 at 09:42 PM »
nako sir nag kaproblema nanaman errr boses lang lumalabas dun sa sub alang base errr
xfi titanium soundcard ko huhuhuh
Logged

Offline louie1

  • Trade Count: (+14)
  • Collector
  • **
  • Posts: 392
  • Liked:
  • Likes Given: 12
Re: No sound
« Reply #13 on: Jan 19, 2012 at 10:33 PM »
center ata ang na tap mo...kung red ang naka connect dati, try mo yong white.. ;D
Logged

Offline strwere

  • Trade Count: (0)
  • Apprentice
  • *
  • Posts: 43
  • Liked:
  • Likes Given: 0
Re: No sound
« Reply #14 on: Jan 19, 2012 at 10:48 PM »
alang tunog ung red huhuhu ung white boses lang
Logged
Pages: [1]   Go Up
« previous next »