Topic: amplifier setting crossover for front and center speaker

[alx]

guys, ask ko lang anong proper crossover setting ng front left and right and center speakers?

when setup using Ezsetup nilalagay yung front sa 200hz while yun center 100hz.

all speakers are set to small.

may nabasa kasi ako dapat daw 80hz for front and center?

is it 80hz mas may bass then 200hz mas walang bass?

[rochie]

guys, ask ko lang anong proper crossover setting ng front left and right and center speakers?

when setup using Ezsetup nilalagay yung front sa 200hz while yun center 100hz.

all speakers are set to small.

may nabasa kasi ako dapat daw 80hz for front and center?

is it 80hz mas may bass then 200hz mas walang bass?

anong avr ang gamit nyo sir?
yes pag 80hz ang x-over mas may bass(in layman's term) sa speaker compare sa 200hz. ako I set my speakers to small then cutoff at 80hz for front/center then may subwoofer ako. pero try mo din kung meron auto calibration avr mo.

[alx]

sir, using hk 340 with auto setup. nilalagay niya sa 200hz ang front while 100hz for center..

thanks for the reply! 

[audiojunkie]

What's the size of your speakers (LCR) their frequency response and impedance? These info are required if you want set them up manually.

[alx]

What's the size of your speakers (LCR) their frequency response and impedance? These info are required if you want set them up manually.

sir, im using bookshelf only b&w 602s3 and lcr60

[audiojunkie]

sir, im using bookshelf only b&w 602s3 and lcr60

Try to set at 100Hz or below but not lower than 80Hz. Set your sub 10-20Hz higher and adjust the gain for proper integration. play around on phase alignment to get better bass response in your sitting position. Again, adjust the gain if LF over powering your main speakers.

[Nelson de Leon]

sir, im using bookshelf only b&w 602s3 and lcr60

Palagay ko medjo hirap i-drive ng receiver amp mo yun speakers mo kaya nilagay niya sa masmataas na cut-off. However, i agree with master audiojunkie:

Try to set at 100Hz or below but not lower than 80Hz. Set your sub 10-20Hz higher and adjust the gain for proper integration. play around on phase alignment to get better bass response in your sitting position. Again, adjust the gain if LF over powering your main speakers.

Just don't drive it hard, observe and see kung mag-clip ang receiver mo.

[markcrenz]

sir, im using bookshelf only b&w 602s3 and lcr60

those speakers can reproduce 60hz and maybe even down to 50hz. you can safely set your AVR crossover to 80hz.