If I'm not mistaken, the Speltz AntiCables are made from a thick gauge of magnet wire. So this could be a good choice.
http://www.anticables.com/testimonials.html
salamat po sir EdwinDIY
1. Bare copper wire (magnet wire) lower gauge bigger dia. better
2. Teflon Tape (gamit ng mga tubero).
3. Kitchen Aluminum Foil (pambalot ng tira-tira)
4. Ferrite (optional)
4. Shirk tube
5. Connectors
Now your ready..
Cut 4 wires at the same length (don't cut beyond 2.5m, the shorter
the better >2.5m problem with the capacitance and inductance). Tiyaga
lang ang kailangan. Twist the 2 wires and the same with the other 2.
Now you have right channel. Do d same for the other channel.
Now wrap with teflon tape (2 pasada). Cut the aluminum foil into
strips (0.5 inch) then wrap it on top of the teflon tape. Wrap again
with teflon tape on top of the aluminum foil (2x). We are doing this
to prevent RFI and EMF. Finish all the 4 wires. Done? Okay, next
shield it with shirk tubes (red for + black for -). After that, don't
twist the + and - wires (i did twist but the sound is better if not
twisted on my system, try what flavor your system wants). OK, now you
have a pair for left and right channel. Solder your connectors and
your done.. Breakin period 120hrs
Anyone tried this (DIY speaker cable) as replacement for internal wirings of speakers (from drivers to crossover)?Salamat po...