DIY PCB Etching Machine Project (the JD Labs way)
Hay salamat naman at nakagawa din ako nito... matagal ko na gusto gumawa nito kaya lang walang time. Nakakahiya nga lang pag nakita ni Brader Sonny and aking woodworking hehehe...
I got this motor assembly from an old VHS player, just needed to modify it a bit and add a pivot point.
I used Chicago bolts/nuts as pivot points for my drag link...
Time to make the "drag link" out of a piece of scrap engineering plastic...
Rounded the edges and drilled pilot holes that should fit the Chicago bolts.
Used a number of flat washers to align the two pivot points of the drag link...
Finally attached the drag link...
And that's it! Please see this very short clip and you'll surely appreciate it more...
http://www.youtube.com/watch?v=GpTZ66FpNVg