Topic: Denon A/V Receivers

[jnazareta]

Mga fellow Pinoy DVD members ask k lang po kung maganda ba ang review ng Denon 1801? even 70watts lang per channel kaya nya po ba i-drive ang 200watts RMS speaker ko? TIA!

[powershot]

hello guys,

im using denon 1910, tatanong ko lang sa mga fellow denon users, naka on ba yung dynamic range volume niyo? sakin kasi naka on tapus naka set sa day para mas malinaw yung voice sa center, kasi pag naka off medyo mahina ang voice.. thanks po sa reply.

btw im using polk audio cs10 center, then auto configuration ng audyssey is L/C/R/SR/SL -5/-5/-5/0/+2. what i did is yun center ginawa kong -1

same experience here using denon 1911,. Mahina ang vocals nya. Sa Onkyo 608  mas labas yung vocals nya pero still too bright for my taste, settings ko nga pala Bass +3, treble -6, dynamic EQ:on;light

[joelsoldao]

Hi! Good day! ask ko lang po sana ng advice sa pagset up po ng denon AVR (I have 1509).Natapos ko na po kasi magAudyssey setup. ano-ano pa po ba dapat kong baguhin?nabasa ko po dun sa denon avr thread na change po ung LFE and crossover freq.san po banda binabago un?

Eto po kasi meron sakin.
1.Sp 2.In 3.Op
  Speaker Setup
    12Cr.Over: 80Hz
       12Cr.Over:Adv
           13 Cr.F : 80Hz

alin po dito dapat baguhin? sensya n po. newbie po ako sa ganito.hehe


Thanks po ng marami!:)

[Weng!]

mga masters,

biglang nawala ang Audyssey MultEQ na naka highlight dati sa screen ng denon 2308 ko. di ko rin mahanap ang audyssey selection sa Room Equalization settings, ON and OFF nalang. is there a way to restore the previously stored Auto Cal or i have to re-run Audyssey again? the speaker setup eg. distance, db, x-over & etc are still intact except for the Audyssey light not appearing anymore on the receiver's screen.

thanks

[streetsmart]

mga masters,

biglang nawala ang Audyssey MultEQ na naka highlight dati sa screen ng denon 2308 ko. di ko rin mahanap ang audyssey selection sa Room Equalization settings, ON and OFF nalang. is there a way to restore the previously stored Auto Cal or i have to re-run Audyssey again? the speaker setup eg. distance, db, x-over & etc are still intact except for the Audyssey light not appearing anymore on the receiver's screen.

thanks

Normally, you can set Audyssey MultEQ on or off. Sounds like it is off now so just turn it on. You don't have to re-run MultEQ.

[jeyps11_c]

San ko kaya pwede dispose and Denon 1907 ko. Usable pa naman sa analog, sabi sa Lotte World sira na daw ang digital input (toslink and optical). But the analog inputs and everything else is working perfectly. Sayang naman kung ibenta lang sa bote dyaryo.

[Onkyo606]

San ko kaya pwede dispose and Denon 1907 ko. Usable pa naman sa analog, sabi sa Lotte World sira na daw ang digital input (toslink and optical). But the analog inputs and everything else is working perfectly. Sayang naman kung ibenta lang sa bote dyaryo.

mahal po ba ang mag pagawa sayang naman baka pwede pagawa then benta

[jeyps11_c]

mahal po ba ang mag pagawa sayang naman baka pwede pagawa then benta

Unfortunately mahal pagawa nung board para sa mga digital input. So hindi din worth it pagawa then benta. Baka lugi lang in the end. Kung papagawa mas ok pa yan i-keep na lang as a 2nd gear.

[avshop]

hello guys,

im using denon 1910, tatanong ko lang sa mga fellow denon users, naka on ba yung dynamic range volume niyo? sakin kasi naka on tapus naka set sa day para mas malinaw yung voice sa center, kasi pag naka off medyo mahina ang voice.. thanks po sa reply.

btw im using polk audio cs10 center, then auto configuration ng audyssey is L/C/R/SR/SL -5/-5/-5/0/+2. what i did is yun center ginawa kong -1

after running audyssey you can still tweak the settings to personal preference. with your current setting i suggest increasing the levels of the center. dynamic range volume can actually muffle the sounds depending on the setting.

[joelsoldao]

safe po ba 120hz ung crossover frequency sa lahat ng speakers?

Thanks!

[Stagea]

safe po ba 120hz ung crossover frequency sa lahat ng speakers?

Thanks!

Unless you have really tiny speakers (like those packaged in small HTIBs), then yes.

[Weng!]

Normally, you can set Audyssey MultEQ on or off. Sounds like it is off now so just turn it on. You don't have to re-run MultEQ.

hi sir mark, i have checked the "room equalization" menu, di pala ON and OFF kundi "ON and Manual" nalang ang selection ngayon. before when audyssey was ON, there were few selections like ON, Manual, Audyssey bypass L/R and Audyssey Flat. now, dunno what to do other than re-run audessey but will wait muna your reply.

thanks

[streetsmart]

hi sir mark, i have checked the "room equalization" menu, di pala ON and OFF kundi "ON and Manual" nalang ang selection ngayon. before when audyssey was ON, there were few selections like ON, Manual, Audyssey bypass L/R and Audyssey Flat. now, dunno what to do other than re-run audessey but will wait muna your reply.

thanks

"Manual" means that Audyssey is OFF. With "Manual", you can use a 6-band (I think) parametric equalizer which is a very poor substitute for Audyssey MultEQ.

[Weng!]

"Manual" means that Audyssey is OFF. With "Manual", you can use a 6-band (I think) parametric equalizer which is a very poor substitute for Audyssey MultEQ.

ok, that means time to run audessey again . it happened to me twice already even i locked the settings after each calibration. i was hoping to pull the saved settings somewhere on the menu.

thanks

[joelsoldao]

ano po the best crossover freq for all speakers (except LFE)?

LFE=120hz
fronts=?
surrounds?

Thanks!

[iiinas]

ano po the best crossover freq for all speakers (except LFE)?

LFE=120hz
fronts=?
surrounds?

Thanks!

i think 80hz would be the safest bet.

[joelsoldao]

Thanks po!

[Euphony101]

Mga Bossing,

 Napansin ko lang po na parang maraming quality issues sa denon receivers particularly sa mid to lower end units that came out in the past 3 years.

Is this becoming a generalization for denon's build quality?

[scifi-fan]

I have no issues using a 1610.

Plays everything I throw at it.

[ninjababez®]

Mga Bossing,

 Napansin ko lang po na parang maraming quality issues sa denon receivers particularly sa mid to lower end units that came out in the past 3 years.

Is this becoming a generalization for denon's build quality?

kasama ba ang 1509?
wala kasi akong naging issue sa 1509 ko, meron pala paminsan-minsan na user error

[ichimaru_kenpachi]

just have a noob question here.pag binago ung settings like ung crossover freq and volume on each speakers after ng audessey calibration kailangan ba naka ON ung Dynamic volume (dyn eq: ON) and MultiEQ nakaset sa audessey? ano po ba recommended settings.

[ninjababez®]

just have a noob question here.pag binago ung settings like ung crossover freq and volume on each speakers after ng audessey calibration kailangan ba naka ON ung Dynamic volume (dyn eq: ON) and MultiEQ nakaset sa audessey? ano po ba recommended settings.

turn off dynamic volume.
read more about Audyssey Dynamic Volume

[ichimaru_kenpachi]

so bale master, set the multiEQ to audessey then dynamicEQ to OFF? ok lang po ba yun?

[ninjababez®]

so bale master, set the multiEQ to audessey then dynamicEQ to OFF? ok lang po ba yun?

for late night viewing and you dont want to disturb anyone, turn ON Dynamic Volume and  dynamic EQ ON dapat para maski tahimik maganda parin ang tunog.
check out the link i provided below.  just to have an idea how dynamic volume works  
eto naman sa Audyssey Dynamic EQ

[ichimaru_kenpachi]

Thanks Master!

[meister_r]

for late night viewing and you dont want to disturb anyone, turn ON Dynamic Volume and  dynamic EQ ON dapat para maski tahimik maganda parin ang tunog.
check out the link i provided below.  just to have an idea how dynamic volume works  
eto naman sa Audyssey Dynamic EQ

Ang galing dynamic EQ! Kaso wala yung 2808ci ko Multi EQ XT lang  ... Medyo na iskandalo mga kapit bahay hehe

[Onkyo606]

Ang galing dynamic EQ! Kaso wala yung 2808ci ko Multi EQ XT lang  ... Medyo na iskandalo mga kapit bahay hehe

MultEQ XT is better sir. in fact your CI i believe menas you can get Audyssey Pro done to your, not many receivers are capable of that.

[ninjababez®]

Ang galing dynamic EQ! Kaso wala yung 2808ci ko Multi EQ XT lang  ... Medyo na iskandalo mga kapit bahay hehe

meron yan bro 

[Tempter]

Ang galing dynamic EQ! Kaso wala yung 2808ci ko Multi EQ XT lang  ... Medyo na iskandalo mga kapit bahay hehe

Yeah, unfortunately dynamic EQ and dynamic Volume is not in 2808CI... 

[meister_r]

meron yan bro 

 Sir wala sa face ng AVR eh, wala rin ako nabasa sa manual hehe san kaya nakatago to!?!  nakita ko lang talaga Multi EQ..