do a factory reset on your box
press chnl + and chnl - at the same time
follow instructions
Perform Manual Configuration
a) LNB Type: Dual
b) Lo Band Freq: 09750
c) Hi Band Freq: 10600
d) LNB Power: “On” for the main box; “Off” for the 2nd/3rd boxes
e) Press “OK” button on the remote and set the following:
1) Freq: 11685
2) Polarization: Horizontal
3) Symbol Rate: 18750
4) FEC: 7/8
Worked pretty well for Humax box
Got signal in Cignal now after putting in the settings
Extra information for Humax boxes circa 2010 and earlier - newer subscribers have Pac (like my second box)
To reset there's a reset button aptly marked behind the drop-down panel
the button is small and you need a tool to press it in - it's beside the card slot
ensure the coax cable is not attached
you need to get into the screen that says no signal received
then press the i for info button to get to the menu
then put in the details in the earlier post
re-attach the cable and power off then power on again
wait for the STB starting up to complete - it should work this time