very possible to biamp, just unhook the jumpers on the speaker binding posts and connect two sets of amplifiers.....the caveat is that the two sets of amps must have the same gain...and you will need an active cross-over.....i have one such unit here in case Jun wants to try out...
Thanks sir Tony! Pwede rin po ba ako pa-try ng mga amps ninyo?
Naisip ko lang sa setup ni sir Jun, lalong dumami ang possibilities ng pag-setup ng kanyang audio system:
1) one amplifier --> drives both the 8" and 10" driver (speaker binding posts connected)
2) one amplifier --> drives only the 8" driver (speaker binding posts not attached)
3) one amplifier --> drives only the 10" driver (speaker binding posts not attached)
4) two amplifiers, one amplifier driving the 8", the other one driving the 10" (speaker binding posts not attached)