Hi sealander,
You can check your Philips player and check the HDMI audio and is should be set to raw/passthrough so your avr can do the decoding.
Sir Jnazareta eto po nakalagay sa manual:
Sound
1 Press .
2 Select [Setup] > [Audio] to access the
audio setup options.
• [
Analogue Output]: Select an audio
format for sound output when this
player is connected through the
AUDIO OUT L/R connectors.
• [
Digital Audio]: Select an audio format
for sound output when this player is
connected through the COAXIAL
connector.
• [
Digital Output]: Select a type of digital output:
[
Off] - Disable digital output;
[
All] - Support multi-channel audio formats;
[
PCM Only] - Downmix to two-channel audio signal.
• [
LPCM Output]: Select a LPCM
(Linear Pulse Code Modulation)
output sampling rate. The higher
the sampling rate, the better the
sound quality. [LPCM Output]
is enabled only when [PCM
Only] is selected under [Digital
Output].
• [HDMI Audio]: Enable or disable the audio output through HDMI connection
• [Sound Mode]: Select a preset sound
effect.
Should Iand DISABLE HDMI and select DIGITAL OUTPUT?