it was just a thought since i remember seeing dual driver box designs somewhere (can't seem to remember where). i do remember the drivers being isolated from each other internally though... again, it was just a random thought since i did have 2 pairs of drivers (and only one amp). i'll do some more research and keep you posted.
ah it must be a F.A.S.T. (full range and subwoofer technology) system. Basically you will use the full range driver to handle the highs & mids, crossed it over low so a separate subwoofer driver (specifically designed to handle constant cone excursion, yung tinatawag na "bayo") will take care of the lows (bass), in 2 separate boxes na pinagkabit so it will look like one floorstander. Pero meron din 2 SAME drivers in 1 box volume wired in parallel.
I understand this is gonna be your first full range build? my suggestion is to go the safe route and build a proven box design for your AN, why? because I want you to first experience full range drivers for what they are designed for; a single driver to handle the whole spectrum of sound. After building my Mark Audio full range speakers hindi ko na ginamit yung Wharfedale Dentons ko & after 2 weeks binenta ko na. For me my build is about 2 tiers level above the Dentons SQ wise (the build cost is also a couple of thousands cheaper
) I think i'm done with off-the-shelf speakers.
No need to apologize bro, we're just having a discussion here, idol ko yan si sir Tony, his knowledge in electronics esp tubes is very valuable to the community lalo na sa DIYers kasi hindi madamot yan mag-share ng alam nya