hi, i need some help with my denon 1910
just recently, while i was watching movie, my avr suddenly shut down, but everthing in my HT set up are still running. the standby light is flashing red. ive checked the manual and it says exactly this:
symptom: power switches off suddenly while you are using the AVR-1910, the power indicator will flash red at intervals of approx 0.5 sec.
Cause: 1. use speaker having impedance less than specified.
2. If speaker cable core wires touch each other or the core wires become disconnected from their terminals, the protection ckt will be activated in the event of core wires coming into contact with the AVR-1910 rear panel.
Countermeasure: 1. please use speakers which have the specified impedance.
2. Unplug the power cord, then after twisting the core wires together tightly again, or effecting termination treatments etc, please reconnect once again.
ang ginwa ko po i reconnected all speaker and video wires, i checked all wires kun me nabalatan or kinagat ng daga pero intact naman po lahat. i reconnect all speaker wires to banana plug just to make sure that evrything will be okay.
then just this evening after long hours of rewiring i tried to watch some movie pero sa kasamaang palad ganon parin po.
i have been using my avr and speakers for almost 2 years, wala naman ako nagagalaw sa connection kya nagtataka ako bakit ganito na bigla avr ko. huhu..pls help naman po. gusto ko man iparepair sa service center kaso sa palawan pa ako. ipapaship ko pa cia para lang maparepair. baka maaus ko pa before ko ipadala.
btw: ito po ang simpleng set up ko just in case un need.
panasonic 42 pv80
denon 1910 avr
polk audio tsi 300 front, center and sorrounds
polk audion dsw pro 500 sub
ps3 slim
HDX
castle power line filter
stac avr 1500w
pls help, thanks guys. thanks pdvd.