Hi fellow Pinoydvd members,
I want to ask for assistance po in using the calibration software of denon x-540bt. I bought this as a replacement with my Pioneer vsx-1022 po. My speakers are all wharfedale and the frequency response is listed below po:
Front - Wharfedale Crystal 4 with frequency response of 30hz-2000hz.
Center - Wharfedale WH-2 with frequency response of 80hz-2000hz.
Surround - Wharfedale WH-2 with frequency response of 80hz-2000hz.
Sub - US audio 512D (Don't know the frequency response) but the crossover knob is set all the way to max (I think 120hz or 150hz), Volume level knob was set to 12 o'clock position.
When I ran the Denon Auto setup if made the following changes:
Front - was set to Large and the crossover was set to 40
Center - was set to Large and the crossover was set to 40
Surrounds - was set to Small and crossover was set 90.
Sub - LPF for LFE was set to 120
I change the front and center to small speakers as I always do but my question is, Should I leave the center crossover to 40hz? as the frequency response of my center is only 80hz as the lowest. What would be the ideal crossover settings for my speakers to attain optimal settings. Any assistance po is much appreciated po. Thanks in Advance po sa mga mag susuggest po.